LED strip dimming compatibility checker
Most dimming failures are a protocol mismatch, not a bad part. Pick the signal the building gives you and the strip you want to run, and see the path that connects them, with the driver or decoder models from our table.
Signal to strip
Protocol first, brand second. A protocol match tells you the parts; a 1:1 bench test with the actual dimmer and driver tells you the range and the flicker.
Protocol first, brand second
-
01
Three places dimming can live
On the line side with a phase-cut dimmer, in the driver with a 0-10V or DALI input, or on the DC side with a decoder or controller between driver and strip. The checker names which one your pair needs.
-
02
Channels decide color
Phase cut and 0-10V carry one channel: intensity. Tunable white needs two, RGBW three or four, pixels a data stream. A single-channel signal cannot drive color, whatever the brand.
-
03
120V strip is the exception
Line-voltage strip has no driver to talk to, so it dims only by phase cut: TRIAC or ELV. Every other signal means a 24V run.
-
04
What this does not tell you
The dimming range, the low-end flicker and whether a specific dimmer's minimum load is met. That is a bench test with the actual parts, which we run before the schedule is final.
Reading the verdict
The checker says direct fit. Does that mean my dimmer brand works?
It means the protocol matches and the parts exist in our table. The brand, the model and its minimum load decide the range and the flicker, which only a bench test with the actual dimmer shows. We run that test before the schedule is final.
Why can 0-10V not dim RGBW?
A 0-10V signal is one channel. RGBW needs three or four channels set independently, which a DMX, DALI DT8 or RF controller provides. 0-10V can still set the overall intensity through a master dimmer ahead of a color controller, as a system design.
Can I dim 120V strip from a DALI system?
Not directly. DALI has no line-voltage phase-cut output; a DALI relay switches the circuit on and off. For dimming on a DALI system, run 24V strip with a DALI driver or decoder.
What is the difference between a decoder and a controller?
A decoder turns a control protocol into PWM for the strip and needs a source such as a console or a wall panel. A controller holds the scenes itself and takes commands from an app, remote or panel. Both sit between the driver and the strip.
Send the control spec and we match the drivers
The control system, the zones and the strip families are enough. An engineer replies with the driver and decoder schedule, the bench-test results and the wiring, in writing.
- Trade & project orders
- Drawings welcome
- US-based support