UL 2108 vs UL 8750 vs UL 1598: Which Listing Does an LED Strip Need?
UL 2108 covers the LED strip system, UL 8750 the LED parts inside, UL 1598 the finished fixture. A product-form table and a certificate check for submittals.
Specification, power, installation, troubleshooting, code and cost guides for contractors, distributors and lighting designers who already know LED.
UL 2108 covers the LED strip system, UL 8750 the LED parts inside, UL 1598 the finished fixture. A product-form table and a certificate check for submittals.
A 50 m neon flex reel is a supply length, not a run. Plan each cut piece against its one-feed limit, feed points, drivers, cut marks and sealed end caps.
Opal passes roughly 70–80% of strip light, clear 90–95%. LED pitch and channel depth set the dots; the cover only hides them. Plus the frosted middle option.
LED strip lumens per watt runs from 30 to 190 across our builds. Compare efficacy only at the same level, build, CRI and test method, then add driver losses.
Cove lumens per foot start from the light you need on the ceiling. Work back through setback, lip, finish and diffuser losses to a strip tier and driver load.
Choose LED strip color temperature in three gates: what the room is for, what is in it, and what sits next to the strip. Five-point table and zone rules.
Where the driver goes on an under-cabinet LED strip job: six locations ranked by service access, Class 2 sizing per run, junction boxes, lead wire and dimming.
120V LED strip runs 98 ft from one feed; 24V strip wins on Ra, cut length and 0-10V or DALI control. Four gates decide the spec, plus wiring and listing rules.
Setback and beam angle work as a pair. See where each angle lands on the wall, which of our optics fit which wall, and how to run a mock-up for even light.
A dim far end is voltage lost after the driver: in the feed cable, the strip copper and the joints. See the AWG table, run limits and the fixes that work.
24V and 60 W do not make an LED driver Class 2. See what the inspector checks on the label, the cable and the separation, and how to split big loads safely.
The dimmer never touches a 24V strip; the driver does. Pick TRIAC, 0-10V or DALI by the job, then check ELV vs MLV, the 1% low end, loading and PWM flicker.
Send your run lengths, color temperature, and CRI target. You will get product options, documentation, and a real lead time, with clear pricing.